Grading Of Copper Slag Aggregate With Fine Aggregate

  • Study of the Properties of Concrete Containing Copper Slag

    replacement of copper slag as a fine aggregate fine Fig.5. Compressive strength for various replacement percentage of copper slag in concrete. 3.3 Rapid Chloride Ion Permeability Test Results (RCPT) For normal concrete, the average charge passed was found to be 950.5 coulombs and for copper slag admixed concrete the maximum charge passed was 1538.5 coulombs after 28 days

  • Effect of copper slag as a fine aggregate on the

    In order to control the bleeding in concrete mixtures when incorporating copper slag as fine aggregates, Ueno et al. suggested a grading distribution of fine aggregate based on particle density. The study investigated the maximum size of slag fine aggregate that does not significantly influence the amount of bleeding and the required plastic viscosity of paste to control the amount of bleeding

  • Copper Slag As Fine Aggregate For High Performance Concrete

    Keywords: copper slag, fine aggregate, concrete, strength, workability, density. 1 Introduction Aggregates are considered one of the main constituents of concrete since they occupy more than 70% of the concrete matrix. In many countries there is scarcity of natural aggregates that are suitable for construction whereas in other countries the consumption of aggregates has been increased, in

  • Copper slag as fine aggregate for high performance concrete

    Copper slag as fine aggregate for high performance concrete K. S. Al Jabri Department of Civil and Architectural Engineering, Sultan Qaboos University, Sultanate of Oman Abstract This paper presents results from an experimental investigation carried out to study the potential use of copper slag as fine aggregate on the strength of both normal and high strength concrete. Concrete mixtures were

  • Utilization of Copper Slag in MSand as Partial

    replacing Copper Slag as fine aggregate with proportions (by weight) of Copper Slag added to concrete mixtures were as follows: 0% (for the control mix), 20%,,30%, and 40%.

  • Study on Glass Fibre Reinforced Concrete with Partial

    included by replacing the fine aggregate by copper slag with 60% and by varying the volume fraction of glass fibre 0.5%, 1% and 1.5%. The grade of concrete is M20. The specimens were cured for 7 and 28 days. The basic properties such as compressive strength, split tensile strength and flexural strength are studied. Based upon the results obtained it was concluded that, addition of glass fibre

  • A Study on the Partial Replacement of Fine Aggregate with

    materials for clinker, cement replacement, coarse and fine aggregates. The use of copper slag in cement and concrete provides potential environmental as well as economic benefits for all related industries, particularly in areas where a considerable amount of copper slag is produced. This project report reviews the characteristics of copper slag and its effects on the engineering properties of

  • Copper Slag Used As A Fine Aggregate Pdf belgianpress

    Sales Inquiry Copper Slag Used As A Fine Aggregate Pdf. Vol. 5, Issue 12, December 2016 Effect of Copper Copper slag has physical properties similar to the fine aggregate, so it can be used as a replacement of fine aggregate in concrete.

  • A Study on the Partial Replacement of Fine Aggregate with

    materials for clinker, cement replacement, coarse and fine aggregates. The use of copper slag in cement and concrete provides potential environmental as well as economic benefits for all related industries, particularly in areas where a considerable amount of copper slag is produced. This project report reviews the characteristics of copper slag and its effects on the engineering properties of

  • Strength Performance of Alkali Activated Slag Concrete

    The fine aggregate grading can between a „coarse‟ for zone I to „fine‟ for zone IV. The results of sieveanalysis of both sand and CS used as fine aggregates here in this study are compared with the four suggested standard grading zones shown in Table 2. The results show that both sand and CS conform to Zone II, as per IS: 383 – 1970. Table 1 Chemical composition of GGBS and Copper

  • copper slag used as a fine aggregate pizemball.fr

    fine aggregate by copper slag, Concretemixes, viz. Conventional concrete mixes with varying percentages of copper slag (10, 20, 30 and 40%) as fine aggregate replacement material were investigated. The compressive strength test was carried out on 4 concrete mixes at the ages of 7, 14 and 28 days.The effect of

  • grading of copper slag aggregate with fine aggregate

    Table Sieve Analysis of fine, Coarse Aggregate, and Copper Slag. IS sieve size in mm Coarse aggregate Cumulative % retained Fine aggregate Cumulative

  • grading of copper slag aggregate with fine aggregate

    grading of copper slag aggregate with fine aggregate. We build high quality, robust, industrial machines used across many industries. Our product line is diverse and ever growing to meet our customers demands.

  • Estimating the Strength of Concrete Cube using Copper Slag

    The fine aggregate is replaced with copper slag in proportions of 0%, 20%, 30%, 40%, 50% and 60% Tests were performed for properties of fresh concrete and hardened concrete.

  • PROPERTIES OF CONCRETE CONTAINING WASTE COPPER SLAG

    suitability of the slag for use as fine concrete aggregate from the point of view of gradation. Concrete was made with a mix design of 1:1.5:3 (1 part cement 1.5 parts sand and 3 parts coarse aggregate).

  • Effect of copper slag as a fine aggregate on the

    Effect of copper slag as a fine aggregate on the properties of concrete 325 obtained from Seowon Co., Ltd. The copper slag was ground in the laboratory into a fine powder of the

  • Effect Of Copper Slag As A Fine Aggregate On Properties Of

    replacement of fine aggregate by copper slag and flexural strength increased by 14 % for 40 % replacement. Many researchers have investigated worldwide on the possible use of copper slag as a concrete aggregate

  • Studies on Alkali Activated Slag Mortar with Copper Slag

    Studies on Alkali Activated Slag Mortar with Copper Slag as Fine Aggregate 528 International Journal of Earth Sciences and Engineering ISSN 09745904, Vol. 08, No. 02, April, 2015, pp. 527531

  • coper slag reaplcement for fine aggregate plasmar.au

    Optimum content of copper slag as a fine aggregate in high strength concrete. copper slag as a fine aggregate optimum content of copper slag replacement idea is to use copper slag as replacement of fine aggregate.Due to several costs of labours for compaction we can go to self compacting concrete.

  • PROPERTIES OF CONCRETE FINE AGGREGATE PARTIALLY AND

    the incorporation of up to 80% Copper slag as substitution of fine total (sand), and can be successfully utilized as a part of basic cement. Likewise as rate of Copper Slag expanded the thickness of cement expanded. The workability of cement expanded with expansion in rate of copper slag. Durability of copper slag is observed to be more, which expands the compressive and flexural strength of

  • Effect of Silica Fume on Concrete Containing Copper Slag

    partially replacing fine aggregate by copper slag and cement by silica fume for M30 grade concrete. Fine aggregate was partially replaced with copper slag at 0, 20, 40 and 60 %. Cement was partially replaced with silica fume by 0, 4, 8 and 12 %. In this study, w/c ratio is fixed as 0.45. Table 7 shows mix proportion of concrete and Table 8 shows the type and notation of mix in this study

  • USE OF GRANULATED BLAST FURNACE SLAG AS FINE AGGREGATE

    USE OF GRANULATED BLAST FURNACE SLAG AS FINE AGGREGATE IN CEMENT MORTAR M C Nataraja1*, Various types of slag from copper and steel industry are being used in mortar and concrete (Pundhir et al., 2005, Khalifa et al., 2011, Mohammed Nadeem and Pofale, 2012, and Tamilarasan and Perumal, 2012). The use of Granulated BlastFurnace Slag (GBFS) as an aggregate

  • USE OF COPPER SLAG AS FINE AGGREGATE ijiert

    The addition of copper slag as fine aggregate in various bituminous mixes improves interlocking and eventually improves the volumetric properties as well as the mechanical properties of the mixes (

  • Use of Granulated BlastFurnace Slag in Concrete as Fine

    This paper reports the results of some experimental studies on the use of nongroundgranulated blastfurnace slag (NGGBFS) as fine aggregate in concrete.

  • Concrete with copper slag fine aggregate — Okayama University

    This study on the appliion of copper slag as fine aggregate for concrete has been started with the expectation of large amounts of consumption. Many researchers have already found it possible to use a copper slag as a concrete aggregate. However, it also has been clear that the concrete with copper slag has some problems. One of them is excess bleeding attributed to the glassy surface of

  • Effects of Copper Slag as a Replacement for Fine Aggregate

    92 Effects of Copper Slag as a Replacement for Fine Aggregate on the Behavior and Ultimate Strength of Reinforced Concrete Slender Columns used. Table 2 shows the mix design quantities.

  • SCOPE OF REPLACING FINE AGGREGATE WITH COPPER SLAG IN

    Key Words: Copper slag, Fine aggregate, Review, Replacement, Concrete, Strength. I. PREAMBLE Copper slag is one of the materials that can be considered as a waste material which could have a promising future in construction industry as partial or full substitute of any two either cement or aggregates. It is an industrial byproduct material produced during the copper smelting and refining

  • UTILIZATION OF COPPER SLAG AS A PARTIAL IJIRAE

    slag as a replacement of fine aggregate on the strength properties. In this report, M25 grade concrete was used and In this report, M25 grade concrete was used and tests were conducted for various proportions of copper slag replacement with sand of 40%, 80% and in